Building A New Workbench / Assembly Table For The Workshop!

Welcome back to another installment of The Workbench . In this episode I talk about the workbench / assembly table I built for the workshop a few months ago. 

I sort of stalled out on this video because I was not happy with some of the shots, as well as the overall length. I shot this video over the course of two weeks, and had about 25-hours of footage, and the end result was just too long. So I speed things up, and loosely emulated Jimmy Diresta's "Diresta's Cut" style of videos to keep the length down. View Jimmy's videos here: http://bit.ly/19B622s

As I mentioned in the video, I made a mistake when choosing to inset the top surface into the 2x4 top rails, as this will make changing the hardboard top all but impossible. I will rebuild this table when that time comes, and just use a double layer of 3/4" plywood next time. 

Project Type: 
Tools Used : 

Other Articles You Might Like

Review: Lulzbot AO-100 3D Printer part 1Lulzbot AO-100 / AO-101 reviewed

Tutorial: DIY Telescope to PC CableDIY Telescope to PC Cable

Project: LED Strip Bench LightingDIY RGB LED Strip Bench lighting

Review: ISO-TIP Portable  Soldering KitISO-Tip Portable Soldering Kit Review

Article: Arduino Due Overview

Project: 3D Printed Balloon Powered CarPrint a Balloon powered Jet Car with your 3D printer