Arduino

DHT11 Based Temperature Monitoring with NeoPixels
DHT11 Based Temperature Monitoring with NeoPixels
DIY Electronics Arduino
Tutorial Type: Arduino Tutorial Difficulty Difficulty Level 3 Parts Required Part Description Amazon.com Arduino Uno Arduino Uno R3 with Atmega 328P Arduino Eth
Sequencing LED's using Arduino and Vixen Lights
Sequencing LED's using Arduino and Vixen Lights
DIY Electronics Arduino
Learn to sequence LED lights with an Arduino, relays and Vixen Lights, from a STEM class project taught at a local makerspace.
Arduino, GPS, and Remote-Controlled Aircraft
Arduino, GPS, and Remote-Controlled Aircraft
DIY Electronics Arduino
Building a lightweight GPS data logger with a TinyDuino and TinyCircuits shields to map the flight paths of a quad copter and other RC aircraft, without the weight of a full handheld GPS unit.
Getting up and running with the Gertduino
Getting up and running with the Gertduino
DIY Electronics Raspberry Pi Arduino
Getting started with the Gertduino, an Arduino-compatible shield for the Raspberry Pi, including installing the Arduino IDE on Raspbian and driving a motor with the Arduino Motor Shield R3.
Reading Liquid Flow Rate with an Arduino.
Reading Liquid Flow Rate with an Arduino.
DIY Electronics Arduino
Tutorial Type: Arduino Tutorial Difficulty Difficulty Level 2 Parts Required Arduino Water Flow Meter 10k Resistor Breadboard Jumper Wires Tools Required This i
Reading PC Fan RPM with an Arduino
Reading PC Fan RPM with an Arduino
DIY Electronics Arduino
Today we are going to learn how to read the RPM of a PC Fan. This also works well for the Water Pumps used in PC Water Cooling as well as any dc pump or fan that has a rotation sense wire. This is accomplished by counting the falling edge of the square wave generated by the Hall effect sensor that is located inside ...
Tutorial: Burning the Sanguino Bootloader to the ATmega 644P Using an Arduino as ISP.
Tutorial: Burning the Sanguino Bootloader to the ATmega 644P Using an Arduino as ISP.
DIY Electronics Arduino
So you just finished soldering up your Sanguinololu 1.3A board and are ready to test it to see if everything is working properly, but before you can upload any firm ware to the board you need to burn a Bootloader to the ATmega 644P. In this tutorial I will cover using an Arduino or Arduino clone as your ISP programm...