ESP32

Mastering ESP32 Part 2: a laptop showing Boards Manager beside an ESP32 development board and the title Install ESP32 in Arduino IDE
Mastering ESP32 Part 2: Installing and Configuring ESP32 Support in Arduino IDE
Add Espressif's stable board index, install the esp32 core, choose the right board entry, and upload your first sketch to a classic ESP32 DevKit in Arduino IDE 2.
Mastering ESP32 Part 1 card (horizontal)
Mastering ESP32 Part 1: Getting Started with the ESP32: A Complete Beginner's Guide
New to the ESP32? Learn what it is, what's inside, which variant and dev board to buy, how to read the pinout safely, and how it compares with an Arduino Uno.
M5Stack Faces 3 Bottom Board shown at an angle
M5Stack Brings Back Faces With a Third-Generation Bottom Board for Core Handhelds
M5Stack's Faces 3 Bottom Board adds a 600 mAh battery, RGB strips, and a panel bus under a Core controller, with keyboard, gamepad, and calculator panels, from $22.50.
Line drawing of Muse gadget devices with the Muse logo
Meta Releases the Muse Gadgets SDK for ESP32 and Raspberry Pi
Meta's open-source Muse Gadgets SDK lets makers connect an ESP32 board or a Raspberry Pi to the Muse personal AI agent, with screens, audio, sensors, and buttons.
Back of the Wireless-Tag WT32P4C5-43S board showing both ESP32 modules
Wireless-Tag WT32P4C5-43S Puts an ESP32-P4 and ESP32-C5 Behind a 4.3-Inch Touchscreen
Wireless-Tag's WT32P4C5-43S pairs an ESP32-P4 with an ESP32-C5 or ESP32-C61 wireless module behind a 4.3-inch 800 by 480 touchscreen, and it is open for pre-order at $32.
M5Stack ToughC5 controller in its gray enclosure with a cable attached
M5Stack ToughC5 Brings Dual-Band Wi-Fi 6 and Zigbee to a Weather-Resistant Controller
M5Stack's ToughC5 is a weather-resistant ESP32-C5 controller with a 2-inch touchscreen, RS485 input power, dual-band Wi-Fi 6, BLE 5, and Zigbee and Thread radio support.
ESP32 BMP280 I2C Sensor Tutorial card (horizontal)
How I²C Works: Reading a BMP280 Pressure and Temperature Sensor with an ESP32
Learn how I2C moves data over two wires, why pull-up resistors matter, how to find a device's address, and how to read pressure and temperature from a BMP280 on an ESP32.